Beko GNE 134605 E Mode D'emploi page 14

Connection of Water Hose to
the Jug
(in some models)
To connect water to the refrigerator from
a jug, a pump is needed. Follow the
instructions below after connecting one
end of the water pipe coming out of the
pump to the refrigerator as described on
the previous page.
1. Finish the connection by pushing the
other end of the water pipe into the
water pipe inlet of the pump as shown
in the figure.
1a
1b
All manuals and user guides at all-guides.com
2. Put and fix the pump hose into the jug
3. After completing the connection, plug in
To provide an efficient operation of the
C
of the pump while making the water
connection.
C
C
13
EN
as shown in the figure.
and run the pump.
pump, wait for 2-3 minutes after
starting the pump.
You may refer to the user manual
There is no need to use water filter in
case a jug is used.
Pump must be used when jug will be
used.
2