Avaya Advanced 2330 Mode D'emploi page 23

Procedure steps
1. Remove the Advanced Gateway 2330 top cover. See Removing the Advanced
Gateway 2330 top cover.
2. Locate the internal PVIM module connector slot.
See the following figure for reference.
3. Ensure the PVIM slot is clear of debris. Protective tape is placed over the SO-DIMM
and PVIM slots during the manufacturing process; remove this tape if it is
present.
4. Holding the PVIM by its edges, insert the module in the slot on the Main Board,
pushing down gently, but firmly, to fully seat the module. The release latches close
when the PVIM is properly installed.
Removing the Advanced Gateway 2330 internal PVIM module
Use the procedure in this section to remove a PVIM module from the Advanced Gateway
2330.
Prerequisites
• Ensure you have a Phillips #1 screwdriver.
• Ensure the Advanced Gateway 2330 is powered off. You cannot hot swap internal
components.
• Ensure you have an antistatic bag or sheet available for the PVIM that you are
removing.
Procedure steps
1. Remove the Advanced Gateway 2330 top cover. See Removing the Advanced
Gateway 2330 top cover.
Regulatory Information
All manuals and user guides at all-guides.com
Voltage:
Do not open the Advanced Gateway 2330 top cover while the unit is powered.
Advanced Gateway 2330 modules
August 2013 23