Avaya Advanced 2330 Mode D'emploi page 22

English
Prerequisites
• Ensure you have a module ready to install before opening the chassis top cover.
• Ensure you have a Phillips #1 screwdriver.
• Ensure the Advanced Gateway 2330 is powered off. You cannot hot swap internal
components.
1. Remove the three screws securing the left-hand side mounting bracket to the
chassis and the top cover.
See the following figure for reference.
2. Remove the three screws securing the left-hand side of the top cover to the
chassis.
3. Remove the three screws securing the right-hand side bracket to the chassis and
the top cover.
4. Remove the three screws securing the right-hand side of the top cover to the
chassis.
5. Slowly slide the top cover back to take it off of the Advanced Gateway 2330.
Installing the Advanced Gateway 2330 internal PVIM module
Use the procedure in this section to install an internal PVIM module.
Prerequisites
• Ensure you have a PVIM module ready to install before opening the chassis top cover.
• Ensure you have a Phillips #1 screwdriver.
• Ensure the Advanced Gateway 2330 is powered off. You cannot hot swap internal
components.
22 Regulatory Information
All manuals and user guides at all-guides.com
Comments? infodev@avaya.com
August 2013