Publicité
Les langues disponibles
Les langues disponibles
Settings
4
The structure of the Settings menu
The menu for this device is structured as follows:
CAUTION
●
There are items that cannot be modified
without entry.
Picture Adjust
Picture Mode
01
Contrast
02
Brightness
03
Color
04
Tint
05
Color Temp.
06
Gamma
07
Advanced
08
Lens Aperture
09
Reset
10
Input Signal
HDMI
11
COMP.
12
Video/S-Video
13
PC
14
Picture Position
15
Aspect (Video)
16
Aspect (Computer)
17
V-Stretch
18
Over Scan
19
Mask
20
Film Mode
21
28
Adjusts the pattern of the projected image.
Setting: Cinema 1, Cinema 2, Cinema 3, Natural, Stage, Dynamic, User 1, User 2, THX
Adjusts the contrast of the projected image.
Setting: –50 to 50
Adjusts the brightness of the projected image.
Setting: –50 to 50
Adjusts the color density of the projected image.
Setting: –50 to 50
Adjusts the hue of the projected image.
Setting: –50 to 50
Sets the color temperature of the projected image.
Setting: 5800K, 6500K, 7500K, 9300K, High Bright, Custom 1, Custom 2, Custom 3
Sets the gradation characteristics of the projected image.
Setting: Normal, A, B, C, D, Custom 1, Custom 2, Custom 3
Adjusts the contours of the image and detailed composition of the image.
Setting: Sharpness, NR, CTI, Color Management, Clear Motion Drive
Sets the lens aperture.
Setting: –15 to 0
Reset the setting.
Configures HDMI input signal.
Setting: Input, Color Space, Control with HDMI
Configures the input signal for the component video input terminals.
Setting: Y Pb/Cb Pr/Cr, RGB, SCART
Configures the Video/S-Video input signals.
Setting: NTSC, Setup Level, Color System
Configures PC input.
Setting: Auto Alignment, Tracking, Phase, Picture Position
Adjusts the horizontal/vertical position of the projected image.
Configures the screen size of the projected image.
Setting: 4:3, 16:9, Zoom
Configures the screen size of the projected image.
Setting: Auto, 1:1, Full
When set to "On", the projected 2.35:1 image will be stretched vertically to the panel resolution.
Setting: On, Off
Selects whether or not to set over scan for the SD video signal.
Setting: On, Off
Masks (Hides) the outer area of the projected image.
Setting: 2.5, 5, Off
Selects this to view movies shot on film.
Setting: Auto, film, Off
Publicité
