SEVERIN KS 9883 Mode D'emploi page 13

appliance to direct sunlight, and do not position it next to any heat sources (radiators,
cookers etc). If this cannot be avoided, however, a suitable insulation must be installed
between the heat source and the unit.
To ensure sufficient air circulation, maintain a minimum distance of 50 mm between the
rear of the unit and the wall.
If the floor is uneven, the adjustable feet on the unit can be used to compensate and ensure
optimum stability. The whole unit should be installed at a slight angle in such a way that it
leans to the rear: this will ensure that the door closes automatically. However, both front
feet must be set to the same height.
Ventilation
The heated air around the rear of the unit must be able to circulate freely. Therefore, ensure
that the air circulation behind the unit is not obstructed.
Reversible door
The design provides for the door to be reversed, i.e. for right-hinged (default installation) to
become left-hinged.
- Take out the two screws (1) to remove the lower hinge (2).
- Take off the door carefully.
- Unscrew and remove the adjustable foot (4).
- Remove the hinge pin (6) and spring (5).
- Remove the blind covers (7) from the left mounting hole and fit it in the corresponding
place on the right.
- Fit the spring (5) and hinge pin (6) into the left mounting hole (picture II).
- Re-fit the adjustable foot (4) on the right-hand side.
- Replace the door. Ensure that the hinge pin (6) sits properly in its corresponding guide
bushing.
- Hold the door in position and insert the lower hinge (2) in the left-hand side. Secure the
hinge with the two screws (1).
Controls and interior light
●
Before the unit is connected to the mains power after installation, it should be left
standing in position for about 24 hours.
The unit is activated by connecting it to the mains. It is only switched off completely when
the plug is removed from the wall socket.
Note: with the temperature control in its OFF-position, only the compressor is switched off.
13