Wiring Connection - Kenwood DPX530BT Mode D'emploi

INSTALLATION / CONNECTION

Wiring connection

When connecting to an external
amplifier, connect its ground wire to the
car's chassis to avoid damaging the unit.
To front speaker (left)
To front speaker (right)
To rear speaker (left)
To rear speaker (right)
Car fuse box
Ignition switch
Car fuse box
Battery
Rear/ front/ subwoofer output
Antenna terminal Fuse (10 A)
White
White/Black
Gray/Black
Green
Green/Black
Purple
Purple/Black
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
To the metallic body or chassis of the car
Microphone input jack ( 12)
If no connections are made, do not let the wire come out from the tab.
Gray
Brown
(Mute control wire)
Blue/White
(Power control wire/
Antenna control wire)
Light blue/yellow
(Steering remote control
wire)
IMPORTANT : We recommend installing the unit with
a commercially available custom wiring harness specific
for your car and leave this job to professionals for your
safety. Consult your car audio dealer.
To connect the Kenwood navigation system,
refer your navigations manual
To the power control terminal when using the
optional power amplifier or to the antenna
control terminal in the vehicle
To the steering wheel remote control adapter
ENGLISH
29