Kolpin 2100 Instructions D'installation page 2

c) Install the front windshield, the rear windshield and the roof to clamps in
this same order for better access to all hardware during installation. Secure
using supplied hardware as shown below. Ensure proper position of all
components before tightening.
WARNING... Over tightening any components could cause parts
failures.
Button head
screw M5 x 16
Washer M5
Front
windshield
3. Maintenance and Care
Tighten all hardware after first use and periodically thereafter.
 Rinse with lukewarm water; wash gently with mild soap or detergent and lukewarm water, using a soft cloth
 Rinse again. Dry with soft cloth or moist cellulose sponge to prevent water spotting.
 To remove wet paint, glazing compound or grease, rub lightly with a good grade of VM&P naphtha or
NOTICE: Abusive cleaning procedures by hand washing or automated washing equipment will eventually
result in visual hazing, loss of light transmission and coating delamination.
- Fantastik1 - Joy2
Failure to follow these installation instructions completely may void any warrantable components and result in product
damage or personal injury.
2100 - Installation instructions for Youth Polaris RZR 170 shields & roof package – Rev00
Step 2
Step 3
or sponge. DO NOT SCRUB or use brushes or squeegees.
isopropyl alcohol, then wash and rinse. DO NOT USE GASOLINE.
Compatible Cleaning Agents

Aqueous Solution of Soaps and Detergents
- Neleco- - Hexcel,
- Windex5
Placer F.O. 554
Washer M5
Locknut M5
CLEANING:
- Formula
- Lysol3
4091
Step 1
- Pine-Sol4 - Mr. Clean2
WWW.KOLPIN.COM
- Top Job2
2