Kuppersbusch GKST 80 I4 FB Instructions De Montage Et D'utilisation page 32

Instructions for assembly
Electrical connection
• The electrical connection must be carried out by a quali-
fied electrician who is authorised to carry out such work!
• Statutory regulations and the connection specifications issued
by the local power supply company must be strictly observed.
• When connecting the appliance it must be ensured that there
is a device which makes it possible to disconnect it from the
mains at all poles with a contact opening width of at least
3 mm. Line-protecting switches, fuses or contactors are suita-
ble cut-out devices.
When connecting and repairing the appliance disconnect it
from the electricity supply with one of these devices.
• The earth wire must be sufficiently long so that if the strain
relief fails, the live wires of the connecting cable are subjected
to tension before the earth wire.
• Any superfluous cable must be removed from the installation
area beneath the appliance.
• Make sure that the local mains voltage is the same as the volt-
age on the rating label.
• Full protection against accidental contact must be ensured on
installation.
• Important! Incorrect connection may result in the power
electronics unit being destroyed.
No mains cable present in the factory
• To connect the appliance, unscrew the cover of the connection
socket on the underside of the appliance in order to be able to
access the terminal. After connecting the appliance, replace
the cover and secure the connection cable with the strain relief
clamp.
• The connection cable must be at least H05 RR-F.
Power supply
Mains voltage: 400-415V 3N~, 50-60 Hz
Component rated voltage: 230 - 240V
Electrical connections: 6-pole connection
* Attention! Special power supply 230 - 240 V 3~ !
32
Electrical connections: 5-pole connection
* Attention! Special power supply 230 - 240 V 3~ !
Mains cable available in the factory
• The hob has been fitted with a temperature-resistant connec-
tion cable in the factory.
• Connection to the mains is carried out in accordance with the
circuit diagram, unless the connection cable is already fitted
with a plug.
• If the mains cable of this appliance is damaged it will need to
be replaced with a special connection cable. In order to avoid
any risks, this must be carried out by the manufacturer or his
Customer Service.
Electrical connections
* Attention! Special power supply 230 - 240 V 3~ !
GB