Publicité
Assembly instructions
IMPORTANT - Remove any packaging before use, but retain the safety instructions and store them with this product.
IMPORTANT - Remove any packaging before use, but retain the safety instructions and store them with this product.
Base:
Ensure that the lid is closed prior to assembly.
Ensure that the lid is closed prior to assembly.
4
2
E
Position the parts on a flat surface that will not scratch the finish of the nest components, paying close
ÉTAPE 1 - Fixez les bandes de connexion supérieure (4 et 5) et inférieure (2 et
attention to the joint overlap in illustration the 2pcs Upper cross brace(4&5) and 2pcs Lorer cross brace(2&3).
STEP 1 -
3) à l'aide des vis (A) et des écrous (E) fournis, comme indiqué sur la figure ci-
Using the given hardware and hand tighten the braces with screw A + nut F.
dessus. Serrer les vis à la main.
Assembly instructions
Assembly instructions
1
C
H
G
8
(Joining the two halves assembled in step l) Stand the section 1 upright, and place the upper cross
ÉTAPE 2 - Fixez les bandes de connexion supérieures (4 et 5) aux pieds du
STEP 2 -
braces (4&5) close to section 1. Inserting truss head screw C through the hole of section1
châssis en reliant la jambe (1) aux bandes de connexion supérieures avec le
and section 4&5 and install K Keps nut and tighten securely.
boulon (C) et l'écrou (J) comme indiqué sur la figure ci-dessus. Serrer les vis à la
(Installing the lower cross braces and casters) Place the assembled lower cross braces (2&3) under section 1,
main.
Stand the section 6 upright to make it close to section 1 and secrion 4&5. Inserting screw B through
STEP 3 -
section 4&5 and section 6, install G Keps nut and tighten securely.Next insert the threaded caster stem
through the hole in the end of the lower cross brace then through the riser and finally the riser brace.
Install (H) flat washer and (I) Keps nut, repeat this at the remaining (3) aster locations and securely tighten.
J
81
FR
A
5
3
5
B
4 en 5
F
6
2 en 3
Publicité
