Publicité
Les langues disponibles
Les langues disponibles
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
OPERATION
After you connected the spot to the mains, the EUROLITE LED Floodlight 252 6000K starts running.
STAND ALONE-OPERATION
The LED Floodlight 252 6000K can be operated without a controller.
In order to select STATIC WHITE, set dip switch 1 to ON.
In order to select SOUND CONTROL, set dip switch 9 to ON and dip switch 10 to OFF.
DMX-CONTROLLED OPERATION
You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
Addressing the device
Set dip switch 10 to ON.
Dip switches 1 - 9 set the DMX address.
Each device occupies 2 channels. To ensure that the control signals are properly directed to each device,
the device requires addressing. This is to be adjusted for every single device by changing the DIP-switches
as set out in the table below.
The starting address is defined as the first channel from which the device will respond to the controller.
International
L
N
17/35
00049791.DOC, Version 1.1
Publicité
