Publicité
Les langues disponibles
Les langues disponibles
N
1 ] Run house power cable between service panel and hood location. For hood with power cable
2 ] Hang hood from (2) rear mounting screws previously installed. Slide hood back towards
3 ] Secure the hood to the cabinet using two (2) no. 8 x 5/8" round head wood screws (included
4 ] Connect ductwork to hood and use metal foil duct tape to make joints secure and air-tight.
18
Install the Hood (Standard Installation)
OTE:
Two installers are recommended because of the weight of this hood.
access located on back of hood, run the house power cable into the hood through the strain
relief previously installed in step 6 on page 10. For hood with power cable access located on top,
tighten the strain relief to the power cable before inserting the strain relief in the knockout hole.
wall until mounting screw heads are engaged in narrow end of keyhole slots in top of hood.
Tighten screws securely and maintain a hold on the hood until completing step 3.
in parts bag). Insert one (1) screw per side, in the slots (as shown below). Attach power cable
to the hood using the strain relief.
Screw previously
tightened in step 2.
Make sure the damper assembly (or round duct plate) enters the ductwork and that the damper
opens and closes freely.
BACK OF HOOD
DUCTED INSTALLATION ONLY
Publicité
