Publicité
Les langues disponibles
Les langues disponibles
Safety Instructions
Risk of explosion due to sparks
Risk of electrocution
WARNING: do not lift heavy objects without assistance
General
Western CO. declines all liability if the standards for correct installation are not respected and is not liable for
the systems upstream or downstream of the equipment supplied by it.
It is strictly forbidden to make any modifications to the equipment. Any modification, manipulation or
alteration to the product, not specifically agreed with the manufacturer, concerning software or hardware,
shall immediately void the warranty.
Please read this manual carefully before installing and using the product.
• Installation and maintenance of the product must be carried out by qualified personnel only.
• This product is designed and tested in accordance with international standards. The equipment must only be
used for the application which it was designed for.
• The product is used in combination with a permanent power source (battery). Even if the equipment is
switched off, dangerous electrical voltage may occur at the input and/or output terminals. Always turn off
any AC power, the PV strings and disconnect the battery before performing maintenance.
• The product contains no user-serviceable internal parts. Do not remove the front panel.
• Never use the product in places where gas or dust explosions may occur.
• Refer to the specifications provided by the battery manufacturer to ensure it is suitable for use with this
product. The battery manufacturer's safety instructions must always be observed.
Installation and maintenance
• If necessary or if the machines are programmed, contact technical assistance and make a telephone
appointment for remote assistance.
• Before turning on the device, check whether the available power source complies with the product
configuration settings, as described in the manual.
• Install the product in an environment that ensures the operating temperature range. Make sure that there
are no chemicals, plastic parts, curtains or other fabrics that can ignite nearby the equipment. Do not install
in places with constant presence of water and/or high humidity.
• Do not install the plant where it can be exposed to direct sunlight.
• Ensure that there is always sufficient free space around the product for ventilation and that the ventilation
openings are not blocked.
• Never touch the uninsulated cable ends. Use only isolated tools.
• The connections must always be made in the sequence described in this manual.
• The installer of the product must provide means (e.g. cable clamps) to prevent the traction of the cables
from being transmitted to the connections and ruining them.
• In addition to this manual, plant installation operations must include a battery maintenance manual
applicable to the type of batteries used.
• The plant must be monitored and checked periodically to verify its correct operation.
• Do not allow the device to come into contact with moisture, oil, soot and vapours and clean it regularly.
• Install on a wall or solid structure, suitable to support the weight of the equipment.
• Install in easily accessible and safe places.
• Install possibly at human height for the display and status and connection LEDs to be easily viewed.
• The installation of the equipment is carried out according to the plant and the place where the equipment is
installed; therefore, its performance is subordinate to the plant being installed correctly.
WRM60 X
User manual
2
EN
Publicité
