sunjoe SJGC7 Mode D'emploi page 6

Fig. 11
Side panel
M6 x 25
screw
Front angle
clamp
Flat washer
Hex nut
12. Repeat steps 8 – 11 to assemble the other side panel.
13. Lay the cart box in the upright position. Remove the front
panel by sliding it up and remove the four large washers
used as shims (Fig. 12).
Fig. 12
Front
panel
14. Assemble the supporting tube using four M6 x 50 screws
through the side panels and the supporting tube. Secure
with flat washers and handle knobs (Fig. 13).
All manuals and user guides at all-guides.com
15. Place the handle tube over the side panels and line up the
four holes. Assemble using four M6 x 50 screws through
the side panels and handle tube. Secure with flat washers
and handle knobs (Fig. 14).
Large
washers
M6 x 50
screws
16. Lay the cart upside down. Slide the axle through the axle
clamps (Fig. 15).
6
Fig. 13
M6 x 50
screws
Flat washer
Fig. 14
Flat washer
Flat washer
Supporting
tube
Flat washer
Handle
knobs
Handle
tube
Handle
knobs