Télécharger Imprimer la page

Black & Decker Vitessa IR2010 Guide D'utilisation Et D'entretien page 3

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT SAFETY INSTRUCTIONS
When using your iron, basic safety precautions should
• READ ALL INSTRUCTIONS BEFORE USING.
• Only use iron for intended use.
• To avoid the risk of electric shock, do not
immerse the iron in water or other liquids.
• Always turn the iron to MIN setting before
plugging in or unplugging from the outlet.
Never pull on the cord to disconnect from
the electrical outlet; instead grasp plug and
pull to disconnect.
• Do not allow cord to touch hot surfaces. Let
iron cool completely before putting away.
Loop cord loosely around iron heel and clip
the cord together with the provided plug
clip when storing.
• Always disconnect iron from electric outlet
before filling with or emptying water,
cleaning, and when not in use.
• Do not operate the iron with a damaged
cord or in the event the iron has been
dropped, damaged, or is leaking. To avoid
risk of electric shock, do not disassemble
the iron. Call the appropriate toll-free
number in this manual. Incorrect reassembly
can cause a risk of electric shock when the
iron is used.
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified person in
order to avoid a hazard. Please call the
appropriate toll-free number listed in the
warranty section of these instructions.
• Close supervision is necessary for any
appliance being used by or near children. Do
SAVE THESE INSTRUCTIONS.
This product is for household use only.
POLARIZED PLUG
This appliance has a polarized plug (one blade
is wider than the other). To reduce the risk of
electric shock, this plug is intended to fit into
a polarized outlet only one way. If the plug
does not fit fully into the outlet, reverse the
plug. If it still does not fit, contact a qualified
electrician. Do not attempt to modify the plug
in any way.
IR2000Series_28942_ESF_IB_C.indd 3
IR2000Series_28942_ESF_IB_C.indd 3
always be followed, including the following:
not leave iron unattended when plugged in
or on an ironing board.
• Burns can occur from touching hot metal
parts, hot water, or steam. Use caution when
you turn the iron upside down - there may
be hot water in the reservoir. Avoid rapid
movement of iron to minimize hot water
spillage.
• The iron must be used and rested on a
stable surface.
• When standing the iron on its heel, ensure
that the surface on which the iron is placed
is stable.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory, or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
• Children should be supervised to ensure
that they do not play with the appliance.
SPECIAL INSTRUCTIONS
• To avoid circuit overload, do not operate
another high wattage appliance on the same
circuit.
• If an extension cord is absolutely necessary,
use a cord rated 10 amps or higher. A cord
rated for less amperage can result in a risk
of fire or electric shock due to overheating.
Care shall be taken to arrange the cord so
that it cannot be pulled or be tripped over.
TAMPER-RESISTANT SCREW
Warning: This appliance is equipped with a
tamper-resistant screw to prevent removal
of the outer cover. To reduce the risk of fire
or electrical shock, do not attempt to remove
the outer cover. There are no user-serviceable
parts inside. Repair should be done only by
authorized service personnel.
Note: If the power cord is damaged, please
contact the warranty department listed in
these instructions.
3
6/8/22 2:27 PM
6/8/22 2:27 PM

Publicité

loading