Cardin RADIOSHIELD CDR4 Mise En Service Et Utilisation page 19

Dip-Switch S3
1 2 3 4
ON ON OFF OFF
ON ON ON OFF
ON ON OFF ON
OFF OFF OFF OFF
OFF OFF ON OFF
ON OFF OFF OFF
ON OFF ON OFF
ON OFF OFF ON
OFF ON OFF OFF
Mode
Low power use: communications mode using different radio channels to
1
avoid interference - channel 1 for security devices with firmware V3.0 or later.
Low power use: communications mode using different radio channels to
2
avoid interference - channel 2 for security devices with firmware V3.0 or later.
Low power use: communications mode using different radio channels to
3
avoid interference - channel 3 for security devices with firmware V3.0 or later.
Broadcast: The stationary unit checks the status of the transceiver interface
4
every 30 seconds. If a reply is not received from one or more safety devices
the system will set their statuses to 'alarm' .
Broadcast: Same as mode 4 but it is reserved for systems made up of
5
security devices fitted with firmware V2.0 or later.
Controlled loads: The stationary unit checks the status of the security
6
devices when asked to by the ECU. Only for photoelectric cell security devices.
Controlled loads: Same as mode 6 but also compatible with the safety edge
7
security devices.
Controlled loads: Same as mode 7 but the interface is powered by the controlled
8
load output on the ECU. This mode also supports battery powered operation.
Warning lights: The stationary unit will check the security device status each
9
time the warning light output on the ECU is actived.
Function mode settings
Description
19