ALPATEC F 500 FC Mode D'emploi page 13

Notice Fontaines 3/07/06
CARE AND CLEANING OF THE DISPENSER
Drain from water dispenser
The remaining water should be drained from the water tank when the tank is to be cleaned or the water
dispenser will not be used for a long time.
1. Set the switch on the back of water dispenser to off position, and unplug the power cord of the water
dispenser.
2. Remove the bottle from the water dispenser.
3. FOR MODELS F 500 FC AND F 500 CT ONLY : this step is to cool the water inside the appliance,
in order to avoid any burn risk during the draining :
Place a container that can withstand the hot water temperature under the hot water tap of the water
dispenser, open the hot water tap with hand to allow water flow into the container, until the water flow-
ing out is close to room temperature. Continuously pour water into the top cup of water dispenser as
needed (water should be poured in proper amount, to avoid overflow of water from the top cup).
4. Drain the water in the water dispenser into a container until no water flows out from the tap.
5. Put the water dispenser on a basin, and lift it by about 3 inches. Remove the drain plug as shown and
complete drain the water from the water dispenser.
6. After complete draining, fit on the plug, cover and screw again.
Warning:
• Do not hold the dispenser up side down to drain the water. It may cause the water flow about the inside
unit and short circuit may occurs.
• It is strictly forbidden to remove the silica gel plug when there is hot water in the water dispenser.
• Before turning on the power supply and connect
the power switch on the water dispenser, make sure there is a bottle with sufficient water on the
water
dispenser, and water can flow out from both taps. (Please refer to "Loading the dispenser").
15:53 Page 13
CARE AND CLEANING OF THE DISPENSER
0,33L-5L Bottle
5L Bottle
Adaptator
13