Loading The Dispenser - ALPATEC F 500 FC Mode D'emploi

Notice Fontaines 3/07/06
Specific components
Model
Part No.
11. Red Indicator
12. Double colour
Indicator - RED
12. Double colour
Indicator - GREEN
13. White switch
14. Black switch
NOTE : To use hot water function and cool water function, press 0/I button on the back side of appliance (13
and/or 14) when the button is on "I" or "marche" position, the appliance is switch on. When the button is on
"0", the appliance is switch off.
The words 'froid" and "chaud" are only indication.
Features/model
Hot water tank capacity and first
time to warm up (88°C)
Icy water tank capacity and first
time to cool (<12°C)
Normal water
• Make sure the dispenser is unplugged with both the hot and cold power switched off.
• Wash hands and wipe the adaptor and the top of the bottle with a clean cloth.
• Avoid touching the part of the bottle and adaptor that will be in contact with the water dispenser.
• Make sure the water level in the top of the dispenser is low enough to allow for proper bottle installation.
Failure to do so may cause the dispenser to overflow.
• Please refer to "care and cleaning of the dispenser" for using the water dispenser for the first time or after
its maintenance.
15:53 Page 11
F 500 FC
Hot and Cool
Heating is in progress
when it is ON.
Cooling is in progress
when it is ON.
the set temperature is
reached when it is ON
Heating power switch
Cooling power switch
F 500 FC
Hot and cool
420 ml . 10 min
350 ml . 40 min
---

LOADING THE DISPENSER

LOADING THE DISPENSER
F 500 FT
Cool & Normal
Indicates power ON
Cooling is in progress
When it is ON
the set temperature is
reached when it is ON
---
Cooling power switch
F 500 FT
Cool and normal
---
700 ml . 40 min
Direct flowing
11
F 500 CT
Hot & Normal
Heating is in progress
when it is ON.
---
the set temperature is
reached when it is ON
Heating power switch
---
F 500 CT
Hot and normal
800 ml . 10 min
---
Direct flowing