Lexmark OptraImage 242 Guide D'installation page 17

Step 9:
requirements
See "Emission Notices" on page 30 and
"Telecommunications Notices" on
page 31 for more FCC information.
Configuration is a task usually done by a
network administrator or system support
person. If you are prompted for a
password during the following
instructions, see your primary system
support person for help.
If you are changing fax modes, you must
click Submit before you can access the
configuration page.
OptraImage Setup Guide
Set up to send and receive
faxes
FCC fax
Manual fax
setup
Set up to
send faxes
During fax setup you must assign some basic information.
The Telephone Consumer Protection Act of 1991 requires all
outgoing faxes to contain the following information in a
margin at the top or bottom of each transmitted page, or on
the first page of the transmission:
• Date and Time (date and time fax is sent)
• Station Name (identification of the business, other entity,
or individual sending the message)
• Station Number (telephone number of the sending fax
machine, business, other entity, or individual)
If you do not have a TCP/IP environment, you must use the
OptraImage control panel to set your basic fax information.
For specific instructions, refer to the online documentation on
the OptraImage CD. Click View Documentation, Use
OptraImage, and search for More Fax Configuration.
After the IP address is set (using any method), use your
browser to set the required fax information.
1
Type the IP address of the OptraImage in the URL field of
your browser (for example, http://192.168.236.24), and
then press Enter.
2
Click Configuration.
3
Under the OptraImage heading, click FAX Setup.
4
Click Configuration.
17