Renkforce 34 25 23 Mode D'emploi page 36

All manuals and user guides at all-guides.com
If you have connected your AV source
device via the S-video output to the
transmitter, connect the S-VIDEO port
of the receiver with the S-video input of
your AV device and the audio outputs
with the sockets AUDIO OUT.
Infrared signal cable
For controlling the AV source devices from the receiver, you must connect the infra-
red signal cable with the IR mouse.
Attach the IR mouse in front of the AV
source device(s) to be controlled.
The IR mouse must point towards the
infrared receivers of the devices to be
controlled.
Plug the infrared signal cable's plug into the
transmitter's REMOTE OUT connection.
30
Only use one type of connection,
never connect the scart port and the
S-video port at the same time with the
AV device.
The IR mouse can be attached to the
bottom with the adhesive pad.
The maximum distance to the IR recei-
ver is 50 cm, the angle should not
exceed +/-15°.
The position of the IR receiving sensor
on the device you want to control can
be seen in the corresponding operating
instructions.
Operating Instructions
English