Failsafe Function - GM Racing XG-6i Manuel D'utilisation

STEERING DUAL RATE (ST.D/R)
FLASH
Steering Dual Rate is used to change the action of steering servo when turning the steering
wheel. The default setting is 100%. The adjusting value range is 20% - 120%.
Setting
1. Press INC-Button, the ST.DR-LED fl ash green, showing the value of the steering servo is
increased. When LED appears all along red, ST.D/R reaches maximum value.
2. Press DEC-Button, the ST.DR-LED fl ash in green, showing the value of the steering servo
is decreased. When LED appears all along red, ST.D/R reaches maximum value.
3. The ST.DR-LED appears red, showing that exactly 20%, 100% and 120% is selected,
otherwise the LED disappear.s after adjusting.
Note: Keeping both INC and DEC-Button pressed, the transmitter will reset. TH/ST Trim will
go to neutral, Steering Dual Rate (ST.D/R) returns to default volume. Also the failsafe setting
will be reset.

FAILSAFE FUNCTION

Die XG-6i 2.0 FHSS is equipped with a failsafe function. In case of signal loss or empty trans-
mitter batteries the throttle and steering servo will go in a preset position to avoid damage to
the model. The throttle position is adjustable, we recommend to preset the brake position for
gas cars, electric cars also brake position or neutral.
Setting
1. Make sure the transmitter-/receiver power is enough.
2. Put the throttle trigger in the desired position (full brake), keep the „F/S"-button till „ST.
D/R"-LED fl ash.
3. Then release „F/S"-button, Failsafe is set.
94002 GM-Racing XG-6i 2.0 FHSS Sport Spec
ST.D/R-
left
buttons
Gas Car Brake Position
Electric Car Brake Position
right
16