! If the oven is too hot, the pyrolytic cycle may not start.
GB
Wait for the oven to cool down.
! The programme may only be started once the oven door
has been closed.
To activate the cleaning cycle
1. Press
to switch on the control panel.
2. Press the
icon.
3. Scroll through the menu commands using the control
dial, select PYROLYTIC and press
4. The appliance suggests a "NORMAL" pyrolytic cycle, with
a duration of 1 hour 30 minutes. Other levels of cleaning
may be selected.
• Use the control dial to select one of the following:
-
"ECONOMY": duration 1 hour
-
"NORMAL": duration 1 hour and 30 minutes
-
"INTENSIVE": duration 2 hours.
• Press
again.
5. Press
to begin the PYROLYTIC cycle.
Safety devices
• The door locks automatically as soon as the temperature
reaches a high value; the
• Pressing the
icon cancels the cleaning cycle at any
time.
• If a malfunction occurs, the heating elements will be
switched off.
• Once the oven door has been locked, you cannot change
the duration and end time settings.
Troubleshooting
Problem
A programmed cooking mode
does not start.
The display shows ECO Mode.
An automatic mode has been
selected. "Hot" appears on the
display and cooking does not start.
Fan-assisted cooking has been
selected and the food looks
burnt.
38
All manuals and user guides at all-guides.com
:
.
icon lights up on the display.
Possible cause
There has been a blackout.
The appliance is in standby
mode.
The temperature inside the oven
is higher than the suggested
value for the selected mode.
Positions 1 and 5: the direct
heat could cause
temperature-sensitive
foods to burn.
Programming delayed automatic cleaning
! Programming is possible only after selecting the cleaning
cycle.
1. Press the
icon twice; the end of pyrolysis time will
begin to flash.
2. Turn the control dial to adjust the end of pyrolysis time;
hold the dial in this position to scroll through the numbers
more quickly and make the setting process easier. The
display will show a graphic indicating the delayed start in
bar format.
3. Once you have reached the desired end time, press the
icon again. The delayed start bar will show the current
time, the time remaining until the start of pyrolysis, the
duration and the end of pyrolysis time as a graphic.
4. Press
to begin the pyrolysis schedule.
5. The display shows the remaining time, moving the
delayed start bar backwards.
6. Once pyrolysis has begun, the display will indicate the
remaining time by filling the duration bar.
7. When the time has elapsed, "CLEANING CYCLE
FINISHED" appears on the display and a buzzer sounds.
• For example: it is 9:00 a.m. and the Economy PYROLYTIC
cycle has been selected: default set time 1 hour. 12:30
is scheduled as the end time. The programme will start
automatically at 11:30 a.m.
To cancel a schedule, press the
Once the automatic cleaning cycle is over
Before you can open the oven door, you will have to wait for
the
icon to switch off: this indicates the oven temperature
has dropped to an acceptable level. You will notice some
white dust deposits on the bottom and the sides of your
oven; remove these deposits with a damp sponge once the
oven has cooled down completely. Alternatively, you can
make use of the already heated oven, in which case it is
not necessary to remove the deposits, they are completely
harmless and will not affect your food in any way.
Solution
Reprogram the cooking mode.
Press any button to exit standby
mode.
Wait for the oven to cool down.
We recommend switching
dripping pan positions halfway
through cooking.
icon.