DeWalt DCD470 Guide D'utilisation page 10

English
This heavy-duty stud and joist drill is a professional power
tool. DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Torque

WARNING: This is a high-torque drill. To reduce the
risk of serious personal injury, ALWAYS hold tool
firmly with both hands in the proper position for
operation as shown.
Torque is the twisting action the drill produces in regards
to the rotating bit. As the drill bit meets resistance in the
material being drilled, the motor responds by adjusting the
output torque to meet the requirement up to the maximum
capacity of the motor and gear system.
Bracing the Tool (Fig. D, L)

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold or brace the tool securely in
anticipation of a sudden reaction.

WARNING: To reduce the risk of serious personal
injury, NEVER brace the tool against the battery pack.
With hands in the proper hand position (also refer to Fig. L),
brace the tool as shown in Figure D.
The bit rotates clockwise when the tool is in the forward
position and counterclockwise when the tool is in the
reverse position. Using proper hand position, brace the side
handle 5 or tool body against a stud for better support
(Fig. D).
Fig. D
5
REVERsE
8
Clutch
The DCD470 is equipped with a mechanical slip clutch.
The clutch is active when the low speed (1) is selected.
When the bit or cutter bites into the workpiece, the clutch
will slip and a ratcheting sound will be heard. Release the
trigger. Continued clutching of the tool will reduce the life
of this feature.
E-Clutch® System (Fig. A)
The DCD470 is equipped with the D
E-Clutch® System. This feature senses the motion of the
tool and shuts the tool down if necessary. The red LED
indicator
is engaged.
inDiCATOR DiAgnOsis
OFF
SOLID
Top Handle (Fig. E)
A fixed top handle
for use as an additional handle.
Fig. E
Side Handle (Fig. F)

FORWARD
The two position side handle
either side of tool. Thread the side handle
threaded holes
by hand.
5
Fig. F
e
12 illuminates when the E-Clutch® System
sOlUTiOn
Tool is functioning Follow all warnings and instructions
normally when operating the tool.
E-Clutch® System With the tool properly supported,
has been activated release trigger. The tool will function
(ENGAGED) normally when the trigger is
depressed again and the indicator
light will go out
4 is provided for carrying the tool and
4
WARNING: To reduce the risk of personal injury,
always operate the tool with the side handle properly
installed and tightened. Failure to do so may result
in the side handle slipping during tool operation and
subsequent loss of control. Hold tool with both hands
to maximize control.
5 can be assembled into
13 on desired side. Tighten securely
13
WALT anti-rotation
5 directly into
5