Flex RS 11-28 Notice D'instruction D'origine page 15

RS 11-28
Instructions for use
Before switching on the power tool
Unpack the power tool and accessories and
check that no parts are missing or damaged.
Inserting/changing the saw blades
WARNING!
Before performing any work on the power
tool, pull out the mains plug.
Discharging used saw blade
CAUTION!
Used cutting accessories may become
–
hot. Wear protective gloves!
Ensure that no persons, animals or
–
sensitive surfaces are in the line of fire
when discharging.
 Release tool holder lock by turning anti-
clockwise and hold (1.).
Used saw blade is discharged under
spring pressure (2.).
NOTE!
If used saw blade is not discharged, pull saw
blade forwards out of tool holder.
Inserting new saw blade
Select a saw blade to suit the material to be
machined. Refer to the manufacturer's
catalogues for details of saw blades that can
be used.
CAUTION!
Risk of injury from cutting teeth. Wear
protective gloves!
 Tool holder must be free of saw residue.
Remove contamination with compressed
air or a brush.
 Open tool holder by turning anti-
clockwise (1.), tool holder engages in
end position.
 Insert new saw blade into tool holder and
push in as far as it will go (2.).
 Release lock of tool holder; lock is
engaged under spring pressure.
 Pull saw blade several times to ensure
that the attachment is secure.
NOTE!
If tool holder lock does not engage correctly,
engage tool holder lock by turning in
clockwise direction.
Adjusting the cutting support
WARNING!
Before performing any work on the power
tool, pull out the mains plug.
The cutting support should always rest on
the material when sawing so as to avoid
excessive vibrations.
It is possible, for example, to limit the saw
blade cutting depth by adjusting the cutting
support.
15