Publicité
Les langues disponibles
Les langues disponibles
8.
Secure the Main Harness to the Vehicle Harness
using 1 Tie Wrap.
9.
Remove the Tape securing the Vehicle's 8P and 2P
Pre-Connectors.
10. Disconnect the Wire Jumper connector from the
Vehicle's 2P Pre-Connector.
• Discard the Wire Jumper connector. (This is used for
the power window interrupt circuit.)
11. Connect the Main Harness's 8P Connector to the
Vehicle's 8P Pre-Connector.
12. Connect the Main Harness's 2P Connector to the
Vehicle's 2P Pre-Connector.
- 9 -
Publicité
