Publicité
Les langues disponibles
Les langues disponibles
Prepare the Hood
NOTE: Since this manual covers two range hood models, some details in the following
illustrations may sligthly differ from your unit.
1 ] If present, remove all protective polyfilm from the hood and/or parts.
2 ] Using the finger cup, remove the grease filters from the hood by pushing down
filter out
.
3 ] Remove the EZ1 brackets from inside the hood by cutting off the tie wrap. Remove both screws
holding damper assembly to hood. Remove parts bag (captured behind the damper assembly).
Remove damper assembly from inside the hood and keep the screws for further use.
EZ1
BRACKETS
4 ] Remove the wiring cover (shaded part on illustration below) by sliding it out from the hood
and set it aside.
B
C
and tilting
SCR EWS
DAMPER
ASSEMBLY
9
Publicité
