Orbegozo BB 4000 Manuel D'instructions page 7

BB 4000
21. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a similarly
qualified person in order to avoid a hazard.
22. Do not use this heater with a programmer, timer or any other device that switches the heater on
automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
23. The fireguard of this heater is intended to prevent direct access to heating elements and must be in place
when the heater in use; the fireguard does not give full protection for young children and for infirm
persons.
24. The device should not be placed immediately below a socket base.
25. Do not use this heater in the immediate vicinity of a bath, shower or pool.
26. Never operate the appliance with wet hands! Danger to life!
27. The appliance must be installed so that the switches, thermostat and power cable cannot be touched
directly or indirectly by a person in the bath or shower.
28. The heating appliance must be installed at least 1.8 m above the ground.
WARNING: This heater is not equipped with a device to control the room temperature. Do not use this heater
in small rooms when they are occupied by persons not capable of leaving the room on their own, unless
constant supervision is provided.
These instructions for use belong to the appliance and must be kept in a safe place, when changing owners,
these instructions must be surrendered to the new owner.
SAFE POSITIONING
1. The heater must not be located immediately below a socket outlet
2. For your own safety and that of others: water and electricity are a dangerous combination! Do not use this
heater in the immediate surroundings of a bath, a shower or a swimming pool. Ensure that the appliance
cannot fall into water (bath wash basin, shower cubicle, etc.)
3. Please read also the safety information's before using.
4. Do not use the heater on extremely deep-pile carpets!
5. Do not use the heater in an upright position.
INSTALLATION
- Maintain a sufficient distance between the appliance and walls and objects. Minimum distances.
The heater should be placed at least at 30 cm from the ceiling (from the wall mounting kit). The heater
should be placed at least at 1,80 cm from the floor.
- Whenever the appliance is to be installed in a bathroom, it is necessary to maintain the required safety
zone around it.
- Do not install the appliance so that the heat rays directly bear on walls or adjacent objects.
- For fixture to a wall, proceed in the following manner:
o Unscrew by one turn the screw which determines the inclination of the appliance.
o Turn the wall support to the end of its travel.
o Unscrew the screws which fasten the cover of the wall support and remove the cover.
o Determine the placements of the appliance and with the help of the holes are to be drilled in the
wall.
o Drill four 6 mm holes and insert the supplied dowels.
7