Publicité
Les langues disponibles
Les langues disponibles
7. These pumps can be used in swimming pools, garden ponds (e.g. ponds and / or garden pond,
fountains ...).
If the pump is used for emptying a swimming pool or pond, it should not be used when people or
animals are in the water.
Similarly, to avoid accidents during pump operation, it is strictly forbidden to bathe, to swim, to wash,
or to water animals near the pump.
Ensure to remove the pump before allowing people and / or animals to enter the water.
8. When the pump is immersed, handling should not be carried out using the power cable, but using a
device (for ex. a rope) connected to the carrying handle.
9. Do not use power cable for carrying or hanging up the pump. Use the transport handle.
IV. GETTING STARTED
Before any intervention on product, ensure that product is disconnected from its power source.
4.1- Unpacking
- Remove product from its packaging.
- Check that product and accessories are not damage
4.2- Connecting the evacuation hose (Fig.2&3)
1. Screw the provided universal fitting (connector) (1) onto the pump outlet (Fig.1).
2. Wedge the discharge hose onto the connection section corresponding to the internal diameter of the
hose (Fig.2).
3. Add a fixing collar (hose clamp not supplied) to complete the seal.
N.B.: For large diameter hoses and to obtain the optimum discharge output, it will be necessary to cut
the end of the universal fitting (1) so as to only keep the section suitable for the hose used (Fig.3).
4.3- Adjusting the floating switch (Fig.4)
The float switch (5) has two positions:
- The "auto" position enables the automatic start and stop of the pump.
- The "manual" position allows to start and stop the pump by connecting the plug to the mains.
4.4- Start-up
Note: Before use, clear the outlet line
Observe and respect minimum water level and max delivery height
1. The pump must be in a vertical position: ensure that it is stable during operation.
2. Ensure that the float switch can move freely.
3. The suction holes must never be obstructed. It is therefore preferable that the pump should never
be placed directly on the ground or on the bottom of the well, pond or vessel.
For example, use a brick to support the pump.
Warning: to dry out premises (cellar draining for example) it will be necessary to place the pump
below floor level.
4. During installation, NEVER hang the pump by the power cable or discharge hose.
Hang up the pump using the transport handle (4) or the eyelet (3).
5. Installation must be carried out according to local regulations.
Publicité
