Publicité
Les langues disponibles
Les langues disponibles
6.2
REPLACING THE EMBER BED LIGHT BULBS
Ember Bed Bulb Replacement
Screw
A.
Remove the 2 screws on the bottom left and right corner of the appliance behind the front panel.
B.
Remove the 2 screws holding the main power switch and pull switch down carefully. Before removing
the wires we recommend labelling the 3 wires on the switch.
Ember Bed Bulb Replacement
C.
Lift up and remove the front panel of the appliance.
D.
Locate the 2 ember bed bulbs as shown.
E.
Remove spring clip. Hold socket and pull out old bulb.
F.
Hold socket and push in new bulb (DO NOT exceed wattage). Reattach spring clip.
G.
Repeat steps 4 and 5 for the remaining bulb if necessary.
H.
Replace the front panel and the screws.
I.
Re-install the 3 wires onto the main power supply switch ensuring the wires are in the correct location.
J.
Re-install the switch with the 2 screws that were removed.
Back View
Screw
Screws
Front View
Ember Bed Bulb Replacement
2 screws
Left
Switch
wires
Ember Bed Bulb Location
Ember Bed Bulbs with spring clips
Front View
15
Right
W415-0924 / C / 09.28.12
EN
Publicité
