SNOWJOE 24V-X2-20SB Manuel D'utilisation page 14

Changing Throw Direction and Throw
Height
m
WARNING
Never direct the snow discharge chute at the operator,
at bystanders, at vehicles, or at nearby windows. The
discharged snow and foreign objects accidentally
picked up by the snow thrower can cause serious
damage and personal injury.
Always orient the discharge chute in the opposite
direction from where you, bystanders, surrounding
vehicles, or windows are located.
1. The discharge chute can be adjusted 180 degrees by
rotating the chute crank. Rotate the chute control crank
clockwise to move the discharge chute to the left and
counterclockwise to move the chute to the right (Fig. 19).
Fig. 19
2. Raise or lower the chute deflector to the desired height of
the snow stream by hold the discharge chute handle and
press the chute deflector trigger (Fig. 20).
m
Chute crank
Discharge chute
Fig. 20
Maintenance
To order genuine replacement parts or accessories for the
Snow Joe 24V-X2-20SB cordless snow blower, please visit
®
snowjoe.com or contact the Snow Joe
service center at 1-866-SNOWJOE (1-866-766-9563).
m
WARNING!
Make sure the unit is off and remove the
batteries before performing any maintenance tasks on your
snow blower.
Lifetime Lubrication (Motor + Auger)
Lubrication is not necessary and may damage the unit.
The snow blower is lubricated for lifetime use at the factory
before shipment.
General Maintenance Tips
m
WARNING!
Always switch the product off, remove
the batteries, and let the product cool completely before
inspecting, cleaning, or performing any other maintenance
task.
m
WARNING!
Only perform the repairs and maintenance
work described in this manual. Any other work must be
performed by a qualified technician.
1. Do not attempt to repair the machine unless you have the
proper tools and instructions for disassembly and repair of
the machine.
2. Check bolts and screws at frequent intervals for proper
tightness to ensure that the equipment is in safe working
condition.
3. After each snow removal session, run the snow blower
for a few minutes to prevent the collector/impeller from
freezing. Shut off the motor, wait for all revolving parts to
stop completely, and wipe residual ice and snow off the
unit. Rotate the chute deflector by the chute control crank
several times to remove any excess snow.
14
Discharge
chute trigger
+ Sun Joe customer
® ®