5.6 When fully charged, unplug the charger from the power source, and then the
charging cable from the unit. Replace the Micro USB cover. The head lamp is now
ready for use.
5.7 Recharge the head lamp after use, and at least every 6 months.
6.
OPERATING INSTRUCTIONS
6.1 Place the head lamp on your head and adjust the headband for proper fit.
6.2 Press the ON/OFF button once for high power.
Press again for low power.
Press again to turn light off.
6.3 Motion sensor:
Press and hold the ON/OFF button for approximately 3 seconds, until the button
turns red.
Pass your hand in front of the sensor to turn the light ON/OFF, as needed.
Press the ON/OFF button again, to turn off this function.
6.4 The angle of light may be adjusted.
6.5 Recharge the head lamp after use, and at least every 6 months.
7.
MAINTENANCE INSTRUCTIONS
7.1 After use and before performing maintenance, unplug and disconnect the unit.
7.2 Any servicing should be performed by qualified service personnel.
8.
STORAGE INSTRUCTIONS
8.1 Store inside, in a cool, dry place.
8.2 Take care to avoid/prevent damage to the charging cable and unit. Failure to do
so could result in personal injury or property damage.
8.3 Charge the head lamp's internal battery immediately after purchase, after every
use and every 6 months.
8.4 All batteries are affected by temperature. The ideal storage temperature is at
70°F. The internal battery will gradually self-discharge (lose power) over time,
especially in warm environments. Leaving the battery in a discharged state may
result in permanent battery damage. To ensure satisfactory performance and
avoid permanent damage, charge the internal battery every 6 months.
• 6 •