Publicité
Les langues disponibles
Les langues disponibles
26
XENYX UFX1204
Gain Setting
Step 4: Gain Setting
(EN)
Press the Channel 1 SOLO button.
Press the MODE button under the
VU METER in the main section to allow
the METER to operate in PFL (pre-fader listen) mode.
Sing, Speak, or play at a normal level
through the microphone or instrument
connected to Channel 1.
While singing or playing, turn Channel 1's
GAIN knob. The VU METER will display
the signal level. Set the GAIN so the
loudest peaks reach 0 on the VU METER. Press the
Channel 1 SOLO button again.
Repeat steps 1-3 for any other channels
that will be used.
27
Quick Start Guide
Multi-FX Processor
Step 5: Multi-FX
(EN)
Your mixer has a built-in eff ects processor.
Follow these steps to add eff ects to one or
Processor
more channels.
Turn the FX knob up halfway on each
channel you would like to add an
eff ect to.
Turn the FX SEND and FX RETURN knobs
to "0". You may adjust them later.
Make sure the FX ON button is
pushed in.
Scroll through the eff ects by turning
the FX knob.
Adjust the intensity of the eff ect
turning the edit knob.
If using presets 1-8, 13-14, or 16,
press the TAP/SELECT button to toggle
between two diff erent values
(light off /on) for the second parameter. To adjust
the delay time of presets 9 and 15, hit the
TAP/SELECT button several times in the tempo
of the music piece. Similarly, hit the TAP/SELECT
button several times to adjust the modulation
speed of presets 10-12. The button will start
fl ashing in the corresponding tempo.
Readjust each channel's FX knob to
make sure the right amount of eff ect
is added.
Publicité
