Lux Tools A-GS-20/20T Notice Originale page 22

GB
– Take regular breaks and move your hands at the
same time to promote circulation.
Handling rechargeable devices
• Danger of fire! Only use batteries approved by the
manufacturer. Only use chargers approved by the
manufacturer. Keep battery away from metal
objects that could cause short circuiting when not
in use. There is a risk of injuries and fires.
• Prior to connecting the charger, verify that the
power supply connection corresponds with the
connecting data of the device.
• The fuse must be a residual current circuit-
breaker with a measured residual current of no
more than 30 mA.
• Only charge the battery in closed rooms.
• Ensure that the device is switched off before
installing the battery.
• Never switch on the device during the charging
process.
• Fluid can escape from the battery when used
incorrectly. Battery fluid may result in skin irrita-
tions and burns. Avoid contact! In the event of
accidental contact, rinse thoroughly with water.
Immediately seek the aid of a physician in the
event of eye contact.
Device-specific safety instructions
• Keep all body parts away from the cutting unit.
• Juveniles under the age of 16 and users who are
not familiar with operating the device are not
allowed to use it.
• Make sure you are positioned firmly and with a
natural stance when working with the device.
• Never attempt to remove cut material or hold onto
material being cut while the knife is operating.
Remove cut materials that are jammed only after
the device has been switched off.
• Only work with good light and visibility.
• Never work at above head level! Do not bend for-
wards or lean over backwards!
• Pay attention when walking backwards. Danger
of stumbling!
• Never work in the rain.
• Carry the device by its handle with stationary
blade and applied blade guard. Only store device
in the case.
• Always hold the unit tightly with both hands.
• Make sure there are no stray animals or objects in
the area before starting work. Remove any
objects that may be catapulted from or jammed in
the cutting unit.
• The clothing of the operator should be close-fit-
ting. Avoid wearing loosely fitting clothing. Wear
sturdy footwear and long work trousers.
• Remember that moving parts may also be located
behind ventilation and venting slots.
• Symbols affixed to your tools may not be removed
or covered. Information on the device that is no
longer legible must be replaced immediately.
Read the operating manual before using the
device
22
Be careful when handling the device! Ob-
serve all safety instructions in the instruc-
tions for use!
Protect the device from wet conditions.
Store in a dry location.
Touch parts only then when they are com-
pletely stopped.
Only re-charge the battery pack indoors.
Do not dispose of a battery pack with the
household waste!
Do not dispose of a battery pack in water!
Do not burn the battery pack!
Do not expose the battery pack to sunlight
or increased temperatures!
MAX xx °C MAX xx °C
Personal protective clothing
Wear safety glasses when working with the
device.
Wear ear defenders when working with the
device.
When working with the tool wear sturdy foot-
wear.
Wear safety gloves when working with the
device.
Wear tight fitting clothes when working with
the device.
Your device at a glance
Note: The actual appearance of your prod-
uct may differ from the illustrations.
► P. 3, item 1
1. Cutting equipment border cutter
2. Clamping sleeve for length setting
3. Handle rod
4. Switch lock
5. On/Off switch
6. Battery pack (not included in the scope of deliv-
ery)
7. Unlock button for drive unit
8. Wheels
9. Unlock button for cutting equipment
10. Blade guard for border cutter
11. Cutting equipment for hedge trimmer
12. Blade guard for hedge trimmer
► P. 3, item 2
13. Display for remaining capacity
14. Push button for capacity display
15. Locking button