Ryobi RY3714 Manuel D'utilisation page 40

Problem
Engine will not No spark.
start. [Make sure
on/stop switch
is in the RUN ( l )
position.]
Engine is flooded.
Engine starts but Carburetor requires
will not accelerate "L" (Low Jet) adjust-
properly. ment.
Engine starts, then Carburetor requires
dies. "L" (Low Jet) adjust-
ment.
Engine starts but Carburetor requires
"H" (High Jet) adjust-
will not run prop-
erly at high speed. ment.
Engine does not Lubricant/fuel mixture
reach full speed incorrect.
and/or emits ex-
Air filter is dirty.
cessive smoke.
Carburetor requires
"H" (High Jet) adjust-
ment.
Engine starts, runs, Carburetor requires
and accelerates adjustment to idle
but will not idle. speed.
TROUBLESHOOTING
Possible Cause
Page 40 — English
Check spark. Remove air filter cover. Remove spark
plug from cylinder. Reattach the spark plug wire and lay
spark plug on top of cylinder with the metal part of plug
touching the cylinder. Pull the starter grip and watch for
spark at spark plug tip. If there is no spark, repeat test
with a new spark plug.
With the on/stop switch in the OFF position, remove
spark plug. Move choke knob to RUN position (pushed in
completely) and pull starter grip 15 to 20 times. This will
clear excess fuel from engine. Clean and reinstall spark
plug. Set on/stop switch to RUN ( l ) position. Push and
fully release primer bulb 7 times. Pull starter three times
with choke knob at RUN. If engine does not start, move
choke knob to HALF CHOKE and repeat normal starting
procedure. If engine still fails to start, repeat procedure
with a new spark plug.
Contact a qualified service center for carburetor adjust-
ment.
Contact a qualified service center for carburetor adjust-
ment.
Contact a qualified service center for carburetor adjust-
ment.
Use fresh fuel and the correct 2-cycle lubricant mix
ratio.
Clean air filter. Refer to Cleaning the Air Filter in the
Maintenance section of this manual.
Contact a qualified service center for carburetor adjust-
ment.
Turn idle speed screw "T" clockwise to increase idle
speed. Refer to Adjusting the Carburetor in the
Maintenance section of this manual.
Solution