Ryobi RY3714 Manuel D'utilisation page 18

KICKBACK PRECAUTIONS
See Figures 15 - 16.
Rotational kickback occurs when the moving chain
contacts an object at the Kickback Danger Zone of
the guide bar. The result is a lightning-fast reverse
reaction, which kicks the guide bar up and back
towards the operator. This reaction can cause loss
of control, which can result in serious injury.
PREPARING FOR CUTTING
PROPER GRIP ON HANDLES
See Figure 17.
See General Safety Rules for appropriate safety
equipment.
 Wear non-slip gloves for maximum grip and
protection.
 Hold the saw firmly with both hands. Always
keep your left hand on the front handle and your
right hand on the rear handle so that your body
is to the left of the chain line.
WARNING:
Never use a left-handed (cross-handed) grip or
any stance that would place your body or arm
across the chain line.
 Maintain a proper grip on the saw whenever the
engine is running. The fingers should encircle
the handle and the thumb is wrapped under the
handlebar. This grip is least likely to be broken
by a kickback or other sudden reaction of the
saw. Any grip in which the thumb and fingers
are on the same side of the handle is dangerous
because a slight kick of the saw can cause loss
of control.
PROPER CUTTING STANCE
See Figure 18.
WARNING:
Always use the proper cutting stance described
in this section. Never kneel when using the
chain saw, except when felling a tree as illus-
trated in Figure 23. Kneeling could result in
loss of stability and control of the chain saw,
resulting in serious personal injury.
OPERATION
Page 18 — English
ROTATIONAL
KICKBACK
PROPER GRIP
IMPROPER GRIP
KICKBACK
DANGER ZONE
Fig. 15
Fig. 16
PROPER HAND
GRIP POSITION
Fig. 17