Ryobi RY3714 Manuel D'utilisation page 15

To start a cold engine:
 Set the on/stop switch to the RUN ( I ) position.
 Make sure the chain brake is in the run position
by pulling back on the lever/hand guard.
 Fully press and release the primer bulb 10 times.
 Pull choke knob all the way out to FULL CHOKE
( ) position.
 Pull the starter grip and rope until the engine
attempts to start, but no more than 5 times.
 Push choke knob to HALF CHOKE (
tion.
 Pull starter grip and rope until engine runs.
NOTE: Allow the saw to run in this posi-
tion 15–30 seconds, depending upon the
temperature.
 Push the choke knob in to the RUN (
NOTICE:
Failure to release partial throttle when chain
brake lever is in the brake position will result in
serious damage to the unit. Never squeeze and
hold the throttle trigger while the chain brake is
in the brake position.
To start a warm engine:
 Set the on/stop switch to the RUN ( I ) position.
 Make sure the chain brake is in the run position
by pulling back on the lever/hand guard.
 Pull starter grip and rope until engine runs.
OPERATION
10
X
) posi-
) position.
RUN
HALF
CHOKE
FULL
CHOKE
FULL CHOKE
POSITION
Page 15 — English
PRIMER BULB
Fig. 8
Fig. 9
STARTER GRIP
AND ROPE
Fig. 10