Télécharger Imprimer la page

Mi-T-M Corporation WTP-T03-0MGH Mode D'emploi page 8

Pompes à ordures 3" honda / 4" honda

Publicité

Les langues disponibles

Les langues disponibles

DO NOT USE OLD FUEL OVER 30 DAYS. FUEL SHOULD BE CLEAN
AND FRESH. FUEL AROUND THE BOTTOM OF DRUM CONTAINS DIRT,
IMPURITIES AND WATER. UNUSED FUEL IN TANK (IF KEPT MORE
THAN 30 DAYS) MAY CAUSE ENGINE FAILURE.
BEFORE STARTING ENGINE, PLEASE CHECK IF ENGINE OIL IS FILLED
TO REQUIRED LEVEL.
2.
Make sure suction hose is connected
properly.
Note: Failure to use approved non-
collapsible suction hose and
recommended hose strainer
at all times during operation of
pump will void the warranty of
the pump and engine.
3.
Fill pump with water before use.
4.
Priming: this pump is self-priming,
however it still requires the pump body
to be filled with water. Running the pump
without filling with water can result in
mechanical seal failure.
5.
Hose connections: If the pump fails to pump water in a short time, the suction
hose connection could be leaking air. Stop the engine and check the suction hose
connection and re-start the engine.
As pump is self-priming type, fill water fully from priming port into pump before run-
ning. Insufficient water can cause damage to pump.
CAUTION RUNNING WITHOUT FILLING WITH WATER CAN DAMAGE
MECHANICAL SEAL.
WARNING THIS PUMP IS NOT INTENDED FOR USE WITH CHEMICALS OR
FERTILIZERS. IF USED FOR APPLICATIONS PUMPING CHEMICALS
OR FERTILIZERS, THE 2-YR LIMITED WARRANTY WILL NOT BE
HONORED AS MOST CHEMICALS AND FERTILIZERS WILL CAUSE
PREMATURE CORROSION AND SHORTEN THE LIFE OF THE PUMP.
THE PUMP SHOULD BE FLUSHED WITH CLEAN WATER AFTER
PUMPING ANY LIQUIDS WHICH MAY BE CONSIDERED CAUSTIC OR
CORROSIVE.
8
PRE-OPERATION
Discharge
Trash Pump Operator's Manual
Suction

Publicité

loading

Ce manuel est également adapté pour:

Wtp-t04-0mgh