Publicité
Les langues disponibles
Les langues disponibles
CHANGING ENGINE OIL
IMPORTANT: Change oil after first 20 hours of operation and every 100 hours
thereafter.
1.
Put unit on level surface.
2.
Run engine a few minutes to warm oil.
3.
Stop engine.
4.
Remove oil filler cap and drain plug and drain oil into container. Do not pollute,
dispose of waste oil properly.
5.
Install drain plug. Fill with oil to top of threads. Install cap.
GASOLINE ENGINE OIL
Use oil viscosity based on the expected air temperature
range during the period between oil changes.
Other oils may be used if they meet one or more of the
following:
• API Service Classification SH
• API Service Classification SG
• CCMC Specification G4
• CCMC Specification G5
CLEAN AIR FILTER ELEMENT
1.
Remove wing nut (A) and remove air cleaner cover.
2.
Remove second wing nut (B) to remove air cleaner
assembly.
3.
Separate air cleaner elements. Check both elements for holes or tears. Replace if
damaged.
4.
Wash foam element (C) in solution of household detergent and warm water. Rinse
thoroughly and allow to dry thoroughly. Soak element in clean engine oil. Squeeze
out excess oil.
NOTE: Engine will smoke during initial start-up if too much oil is left on foam.
5.
Remove excess dirt from paper element (D) by tapping lightly on hard surface, or
by blowing compressed air from inside the element. Do NOT brush dirt. Brushing
will force dirt into element fibers. Replace paper element after 300 hours, or if
excessively dirty.
6.
Install air cleaner in reverse order as removed.
NOTE: SEE PICTURES ON NEXT PAGE
Trash Pump Operator's Manual
SERVICE
122°F
50°C
104°F
40°C
86°F
30°C
68°F
20°C
50°F
10°C
32°F
0°C
14°F
-10°C
-4°F
-20°C
-22°F
-30°C
-40°F
-40°C
13
Publicité
