Microphone System Operation - Sony WRT-808A Mode D'emploi

Channel setting
Notes
•
Be sure to set the arrow mark of the channel select switch
to the clicked position of the desired channel number. If
the switch does not click on the channel number, the
desired channel may not be set on the unit.
•
If the channel select switches are operated while the
transmitter is on, the POWER/BATT indicator flashes in
green as a warning.
•
If you set to any channel other than those listed in
"Wireless Channel Lists" on pages L-1 to L-3, the
POWER/BATT indicator flashes in green as a warning.
•
While the POWER/BATT indicator is flashing, the RF
output signal send from the transmitter becomes lower
than the usable level.
While POWER/BATT indicator on the transmitter is
flashing, the RF input indicator on the tuner may light, if
the transmitter locates near the tuner.
Though the RF input indicator lights on the tuner, the
Sony tuner (equipped with muting function) makes neither
noise nor audio output.
•
Make sure that the channel selected is the same as that
selected on the tuner used in the same system.
•
If there is a TV broadcasting station near by, do not use
the station's channel.
US
10
Microphone System
Operation
Microphone connection
Sony microphones F-780/740/730/720/710, etc.
Attach a microphone
to the unit directly or
use a microphone
cable with XLR-3-11
and XLR-3-12 type
connectors.
If noise is heard
Depending on the environment where the system is
installed, outside noise or radio wave may disrupt the
transmission of certain channels.
To select a channel under this circumstance, turn off the
transmitter. Select a channel on the tuner, at which the RF
indicator is off. (A channel free from noise or radio wave
interference is selected.) Then, set the same channel on the
transmitter.
To dettach a
microphone,
press the
microphone
release
button.