Wetelux 89 93 13 Mode D'emploi page 13

Before first Use
Remove the worklight out of the packaging. Keep
packaging materials out of reach of children. There is risk
of suffocation!
Charging the Battery
Before first use, charge the battery of the worklight.
1. Connect the USB charger cable
to the PC USB port output and
the charging socket of the
worklight, as shown in the
picture.
The first LED at the rear side of
the worklight starts flashing and
indicates that the battery is charged. After some time
the other LEDs will also flash.
When all LEDs flash the rechargeable battery is fully
charged. One LED is equal to 20 % charging capacity.
2. After charging process, disconnect the USB cable from
the PC and the worklight.
Hint: During charging, the worklight must not
be operated.
Operation
1. Press the button once. The LED torch light switches on.
2. Press the button again to switch off the torch light and
to turn on the worklight.
3. Press the button again to turn off the worklight.
Operation
13