Beurer 64312 Mode D'emploi page 15

Alternative use in the car
The massage seat cover can also be used in the car with the car adapter supplied. Plug the car adapter
connector plug into the connection jack on the device. Plug the car adapter into the cigarette lighter jack or
an alternative 12 V jack. (e.g. trunk). Operation proceeds as described above.
WARNING
Never have a massage with the massage seat cover while you are driving a car yourself. The
massage, as well as the device setting, distracts you from the road traffic. Your attention to the road
traffic must never be impaired by the device. Therefore only use this device as a passenger or if you
take a break and the vehicle is stationary. Please note that if the engine is off the battery can discharge
under certain circumstance. For some vehicles the 12 V jack only works when the engine is on.
A massage with this seat cover can be very relaxing and regenerating while taking breaks.
9. Cleaning and maintenance
CLEANING
WARNING
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• Do not use the device again until it is completely dry.
First unplug the device and allow it to cool off. Then you can clean it with a cloth which is no more than lightly
moistened. You can also use a mild detergent.
Storage
• Keep the massage device in a cool and dry place where it is out of the reach of children. We recommend
storing the device in its original packaging.
• Avoid any contact with sharp or pointed objects which could damage the device or cover.
10. In the event of problems
Problem
The device is
very loud during
massage.
Massage stopped. The preset maximum period
No massage.
11. Technical specifications
Supply
Input:
Output:
Average active efficiency:
No-load power consumption:
Dimensions:
Poids:
Cause
The seat cover is not fully in
contact with the base.
of operation has elapsed.
The connection to the mains
has been interrupted.
Appliance not connected to
the mains power supply.
Device not switched on.
Remedy
Ensure that the seat cover is supported over its
entire area.
Let the device cool down for at least 15 min.
before using again. Switch the device on again.
Check the plug connection and the contact of the
mains plug with the mains supply.
Make all connections and switch on the device.
Turn the device on using
sage using buttons 2 – 4.
100-240 V~, 50/60 Hz, 0,5 A
12,0 V 0,8 A, 9,6 W
≥ 83,89 %
≤ 0,084 W
45 x 2,8 x 71 cm
env. 813 g
15
and activate the mas-