Smeg C7280NEP1 Notice D'utilisation page 25

Problem
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FastFreeze, or
after changing the tempera‐
ture.
Water flows on the rear
plate of the refrigerator.
Water flows inside the refrig‐
erator.
Water flows on the floor.
Temperature cannot be set.
Possible cause
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The FastFreeze is switch‐
ed on.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
This is normal, no error
has occurred.
During the automatic de‐
frosting process, frost
melts on the rear plate.
The water outlet is clog‐
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
The FastFreeze function
or Shopping function is
switched on.
Solution
Refer to "Operation".
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor‐
ing.
Refer to "Closing the door".
Refer to "FastFreeze function".
Refer to "Closing the door".
The compressor starts after a
period of time.
This is correct.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Switch off FastFreeze or
Shopping manually, or wait
until the function resets auto‐
matically to set the tempera‐
ture. Refer to "Fast‐
Freezefunction" or "Shopping
function".
25