Publicité
Les langues disponibles
Les langues disponibles
A Attaching the circular-cutting and parallel
guide
For sawing circles (dia. 100 - 360 mm) and making
cuts parallel with edges (max. 210 mm).
Attach the circular-cutting guide (
- Slide the rod on the circular-cutting and parallel
guide sideways into the footplate (centre point (c)
faces downwards).
- Set the desired radius (d).
- Tighten screw (b).
Attach parallel guide (
- Slide the rod on the circular-cutting and parallel
guide sideways into the footplate (centre point (c)
faces upwards).
- Set the dimension (e)
- Tighten screw (b).
For a complete range of accessories, see
www.metabo.com or the catalogue.
12. Repairs
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
A defective mains cable must only be replaced with
a special, original mains cable from metabo, which
is available only from the Metabo service.
If you have Metabo electrical tools that require
repairs, please contact your Metabo service centre.
For addresses see www.metabo.com.
You can download spare parts lists from
www.metabo.com.
13. Environmental Protection
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Packaging materials must be disposed of according
to their labelling in accordance with municipal
guidelines. Further information can be found at
www.metabo.com in the "Service" section.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Directive 2012/
19/EU on used electronic and electric equipment
and its implementation in national legal systems,
used power tools must be collected separately and
handed in for environmentally compatible recycling.
14. Technical Specifications
Fig. H. Changes due to technological progress
reserved.
T
= Maximum material thickness in wood
1
T
= Maximum material thickness in non-
2
ferrous metals
T
= Maximum material thickness in sheet
3
steel
n
= Stroke rate at idle speed
0
P
= Nominal power input
1
P
= Power output
2
m
= Weight without mains cable
Fig. G-I)
Fig. G-II)
Measured values determined in conformity with
EN 62841.
Machine in protection class II
~
Alternating current
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Energy-rich, high-frequency interference can cause
fluctuations in speed and eventually standstill.
However, the fluctuations disappear as soon as the
interference fades away.
Emission values
Using these values, you can estimate the
emissions from this power tool and compare these
with the values emitted by other power tools. The
actual values may be higher or lower, depending on
the particular application and the condition of the
tool or power tool. In estimating the values, you
should also include work breaks and periods of low
use. Based on the estimated emission values,
specify protective measures for the user - for
example, any organisational steps that must be put
in place.
Vibration total value (vector sum of three directions)
determined in accordance with EN 62841:
a
= Vibration emission value (sawing sheet
h,CM
metal)
a
= Vibration emission value (sawing wood)
h,CW
K
= Uncertainty (vibration)
h,...
Typical A-effective perceived sound levels:
L
= Sound pressure level
pA
L
= Acoustic power level
WA
K
, K
= Uncertainty
pA
WA
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!
ENGLISH en
13
Publicité
