HoMedics AR-NC02-GB Mode D'emploi page 6

IB-ARNC02-0114-01_Layout 1 12/02/2014 12:09 Page 6
OPERATING INSTRUCTIONS
Fig. 1
Fig. 2
Fig. 3
Fig. 4
TABS
Fig. 5
Fig. 6
All manuals and user guides at all-guides.com
Getting Started
• Take the air purifier out of the box and remove the clear
protective plastic bag.
• Place the air purifier on a firm level surface.
• Before turning ON THE AIR PURIFIER, if you choose to use the
optional VOC filter, you will need to install it and confirm that all
the filters are firmly in place.
Installing the optional VOC filter
1. Open the rear grill by gently pushing the release tabs toward
the outside of the unit. See Fig. 1.
2. Pull the grill away from the body until the tabs at the bottom of
the grill plate easily slide away from the unit. See Fig. 2 & 3.
3. The pre-filter and Nano-Coil filter will be installed already.
Confirm that Nano-Coil filter is fully engaged on centre hub. To
install the VOC/Odour filter (optional), remove the VOC/Odour
filter from the plastic bag. Place the VOC filter into the unit flush
against the pre-filter, secured by four clips. See Fig. 4.
4. Place the tabs at the bottom of the grill plate into the base of
the unit. See Fig. 5.
TABS
5. Hold engaged bottom of the grill plate in place and push the
top of the grill plate back toward the unit. The release tabs at the
top of the grill will click back into place. See Fig. 6.
NOTE: Unit will not operate unless Nano-Coil, pre-filter and
grill are properly installed.
6