Conceptronic C300APRA2 Guide D'installation Rapide page 34

ENGLISH
This chapter describes how to configure the ADSL line of the C300APRA2 using the built-in Quick Start
Wizard. After completing the steps in this chapter your router has been set up for an ADSL connection and
will be able to connect to the internet.
5.1 Factory default settings
The C300APRA2 is preconfigured with several settings. The preconfigured settings can be found below:
IP Address
Username
Password
Wireless SSID
Wireless Channel
Wireless Security
UPnP
When you have changed settings in the configuration of the C300APRA2, they will be saved to the memory
of the router. To restore the factory default settings, press and hold the reset button on the back of the
device for +/- 15 seconds.
5.2 Web-based configuration
The configuration of the C300APRA2 is web based. You will need a web browser for the configuration of
the device.
Note: For configuration of the router it is advised to use a LAN cable connection to the device instead of
a wireless connection.
A. Start your web browser (like: Internet Explorer, FireFox, Safari or Chrome).
B. Enter the IP address of the device in the address bar of your web browser (by default:
http://192.168.0.1/).
C. You will first get a login window asking you for a User name and Password. Enter the default User
name and Password ('admin' and 'admin') and click "OK" to enter the web-based configuration.
34
All manuals and user guides at all-guides.com
5. ADSL configuration
: 192.168.0.1 (DHCP Server for LAN/WLAN clients Enabled)
: admin (small characters)
: admin (small characters)
: C300APRA2+
: Channel 6
: Unsecured
: Enabled