Conceptronic C300APRA2 Guide D'installation Rapide page 33

3. Renew the IP address of your computer with the following commands:
- "IPCONFIG /RELEASE" to release the incorrect IP address.
- "IPCONFIG /RENEW" to receive a new IP address from the device.
If above steps do not solve the IP address problem, you can reset the device to the factory default settings
with the Reset button on the back of the device.
Press and hold the Reset button for +/- 15 seconds to load the factory default settings. When the Status
LED is active again, repeat step B to renew your IP address.
Note: If the problem remains, check if all cables are connected correctly. The ADSL port should be
connected to the ADSL line and the LAN port to the computer.
All manuals and user guides at all-guides.com
3
3
ENGLISH
33