Publicité
Les langues disponibles
Les langues disponibles
Higher up on
Always wear SAFETY GLASSES
when installing hitch
2011 – Present models
Figure 1
Existing studs
Existing nuts
Bumper Beam
Rear
Figure 5
X5 MODELS
Note: Prior to beginning installation make customer aware their exposed lower fascia does require trimming and there are other pieces that will need to be modified to complete
installation.
Get customers approval prior to installation.
1. Remove rear bumper fascia. (A) Gently pull back wheel well molding with the plastic tri m tools to l ocate a plastic ri vet (1 on each side). ( B) Use the drill to remove 2 pl astic ri vets (each
s i de) from the plastic wheel well molding and facia (See Figure 2). Ri vets can not be re -used. Replacements supplied. To remove ri vet, i nsert small center punch or drill bit i nto center to
pus h pin through. (C) Use 8mm socket to remove 16 s crews from bottom of fascia (8) each side. You will have 3 plastic tri m pieces that will come off from this – s et them aside for later.
(D) Remove 4 push ri vets from the top facia area (Located under the tailgate, see Figure 3). Two trim pieces can then be pulled off. (E) Remove reflectors buy using the plastic trim tools.
(F) Gently begin to remove the facia by using your plastic tri m tools. Unclip the electrical on the passenger s ide and remove the fascia.
2. Lower exhaust and disconnect sensor wiring: Us e a 13mm s ocket to remove 2 nuts from the exhaust (1 each side). Next disconnect the back-up sensor wiring a nd hands-free sensor
(Not s hown). Lower ta ilgate to access upper mounting fasteners.
3. Remove bumper beam by using a 18mm deep s ocket on 8 M12 nuts (4 each s ide). Set the bumper beam to the side. Keep the nuts fo r hitch i nstallation.
4. Tri m the bumper beam mounting plate by 1" (See Figure 4). Repeat this process from the opposite side.
5. Appl y blue thread locker to s tuds. Raise hitch into position then sandwich with newly tri mmed i mpact bar.
6. Tighten all M12 fasteners with torque wrench to 65 Lb.-Ft. (88 N*M)
7. Obta in vehicle owners approval before cutting. Tri m fascia using utility knife. (See Figure 5).
8. Rei nstall all fasteners, bumper panel, i nterior trim panel, wiring harness, fascia and bottom appearance panel removed i n Steps 1 a nd 2.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged
should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cu t access or attachment holes with a torch. This product complies with safety specifications and requirements
for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2019, 2022 Horizon Global ™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 76288, 84288, CQT76288
Fasteners
typical
both sides
3.75''
4.0''
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Figure 3
Figure 4
Sheet 3 of 12
76288N
Fastener Kit: 76288F
j
Qty. (4)
Ri vet
Figure 2
07-08-22
Rev. B
Publicité
