Publicité
Les langues disponibles
Les langues disponibles
EN
around the filter for cleaning and
maintenance.
• Do not operate the filter at pressures
above 0.4 bar. Position the filter so that
the inlet and outlet hose connections
are already facing the pool to avoid
unnecessary bending or folding of the
connecting hoses.
• It is recommended to use pipes at the
water inlet and outlet that are equal to
each other and have a diameter equal
to or greater than the diameter of the
fittings provided.
FIRST INSTALLATION
• Connect connection 3 to the suction of
the pump 2 ;
• Connect connection 5 to output 4 of the
pump;
• Insert and secure the tube 6 into the
fitting 5 ;
• Insert fitting 7 into hose 6 and secure it;
• Connect connection 7 to inlet 9 of the
filter;
• Connect connection 3 to output 8 of the
filter.
• Connect the hose from the pool drain to
connection 3 of the pump;
• Connect the filter return hose to the
pool;
• If the pump does not rest properly on
the ground, loosen the grey ring nuts
on connections 5 and 7 to adjust the
connection height. Then tighten the ring
nuts.
• Check that the diverter valve is in the
'FILTER' position.
• Only after you have made all the above
connections should you connect the
pump cable to the power supply.
Publicité
