Uline H-1227 Instructions D'assemblage page 4

3
3
Figure 4
Figure 5
Figure 6
PAGE 4 OF 12
ASSEMBLY CONTINUED
9
8
1-800-295-5510
uline.com
9. Insert the legs (3) into corners between the bottom
and the side. Bolt the leg to the side using two bolts
and nuts per leg. (See Figure 4)
10. Place door and frame assembly (8 & 9) over the
locker body. Make certain the body sides are
inside the frame and not between the frames.
Attach top to frame header and bottom to frame
sill (one bolt each). Finish by attaching the door
and frame assembly to the sides of the locker
body (bolts will be shared with the door and frame
on either side of them). (See Figure 5) If joining a
3-wide unit beside another unit see JOINING UNITS
TOGETHER below.
11. Stand unit upright, and place in desired location.
If joining units together, remove temporary bolts in
frames and bolt adjacent units together through
frames. Check and tighten all permanent bolts.
(See Figure 6)
NOTE: If the temporary bolts are not removed
before the frames are joined side by side, the
frames will have a 1/8" gap between them.
12. For H-1227 and H-5529: Place non-slotted end of
coat rod (10) over projecting tab of top left coat
hook. Slide the slotted end of the coat rod over the
projecting tab in the right coat hook and turn 90˚ to
secure it.
JOINING UNITS TOGETHER
1. If joining a 3-wide unit beside another unit,
temporarily install a bolt and nut into the third and
sixth holes down from the top of the outer frame(s)
that will be joined to the adjacent locker frame(s).
(See Figure 6) The center locker frame can be
bolted complete.
SECURING UNITS
1. Anchor units to wall or floor. Units are not intended
to stand free and may topple if not secured. (Units
standing back to back should be bolted together.)
CAUTION! Care must be taken to assure
that lockers are set plumb and true before
anchoring.
2. If units are not pre-numbered, an optional number
plate (11) may be attached with two #6 x 5/16 drive
screws or push plugs (12).
0821 IH-1227