Uline H-1227 Instructions D'assemblage page 3

1
Bottom
Figure 1
6
Figure 2
Figure 3
PAGE 3 OF 12
Top
2
4
2
1
5
7
ASSEMBLY
ASSEMBLING MAIN PANELS
NOTE: Do not tighten bolts until unit is
completely assembled.
1. Locate and separate the left and right sides (2 and 7).
Identify the top of each panel. The top of each panel
has three holes instead of one.
2. Place back (1) on a protected flat surface so that
the flanges face upward.
3. Bolt left side (2) to the back (1) so that side flange
fits around back (use 7 bolts and nuts - nuts to the
inside). Do not use bottom 2 holes; these will be
1
used for attaching legs in step 8. (See Figure 1)
4. Attach top and bottom (6) to side (2) and back (1) as
shown (See Figure 2). Bolt shelf (4) to back and side.
NOTE: Save one right side for step 7.
5. Bolt an intermediate side and back panel to the
flange of the first locker (use 7 bolts and nuts - as in
step 3). Bolt shelf (4) to back and side. Attach top
and bottom (6) to the first intermediate side and
back panel.
NOTE: A left or right side may be used as
an intermediate side.
6
6. Next attach remaining intermediate side and back
to flange of second back. Then attach remaining
shelf, top and bottom to the intermediate side.
7. Bolt right side (7) to the back so that side flange fits
around back. Attach side to top, bottom and shelf.
(See Figure 3)
8. Attach coat hooks (5) to each locker's left side and
back panel:
• Side – 3rd & 4th holes below shelf (6th, 7th holes
down from top).
• Back – 2nd & 3rd holes below shelf (5th, 6th holes
down from top). (See Figure 2)
0821 IH-1227