BorMann PRO BBP5200 Mode D'emploi page 6

EN
Dust protection cap (a) used
The dust protection cap for protection against the ingress of dust and other dirt in the SDS-Plus drill chuck. Slide the cap over the bit until it contacts the bit
holder.
Set the bit as you would in the SDS-Plus drill chuck.
On / off switch with speed control
Your tool comes with an on / off switch with speed control. The people who are affected by how deeply you push the on / off switch.
With the variable speed control you can change the right rights for each application.
NOTE: We receive to use variable speeds only briefly. Do not use the tool permanently at different speeds. This can be the switch in the long run.
Forward / reverse run
The right / left rotation switch (e) determines the direction of rotation of the tool.
For forward rotation, release the on / off switch, let the tool come to a standstill and then push the right / left rotation switch (e) to the left side of the tool.
In order to reverse the rotational direction turn, slide the switch (e) to the right. The on / off switch is processed in the middle position of the direction of
rotation switch.
WARNING Be sure to change the view of the direction switch.
To switch on and off
To switch on the contact, switch the on / off switch on.
Release the on / off switch to stop.
Maintenance and Troubleshooting
Maintenance
Regular inspection and cleaning reduces the necessity for maintenance operations and will keep your tool in good working condition. The motor must be
correctly ventilated during tool operation. Avoid blocking the air inlets and vacuum the ventilation slots regularly.
WARNING: Always remove the rechargeable battery from the device before all work.
• Replace all damaged or worn parts to ensure the power tool is always ready for safe operation.
• Clean ventilation slots and openings with a brush.
• DO NOT use any solvents or cleaning agents containing chemicals which could damage the plastic parts. Wipe the housing clean with a cloth.
• Always store the tool in a dry, frost-free location beyond the reach of children.
• Store and charge your rechargeable batteries at a cool location. Temperatures above or below normal room temperature shorten the lifespan of the recharge-
able batteries.
• Do not store rechargeable batteries when discharged. Wait until the rechargeable battery has cooled down and charge it completely.
• Rechargeable batteries gradually lose their charge. The higher the temperature, the quicker they lose their charge. For longer storage periods, recharge the
rechargeable battery every one or two months. This will extend the lifespan of the rechargeable battery.
Troubleshooting
Problem
Unit does not start
The battery will not charge
Important: Please note, all repairs/service should be carried out by a qualified person.
6
Possible Cause
Battery not installed properly
The battery is not charged
The battery is not inserted to the charger
The charger is not connected to the socket
The air temperature is too high or too low
WWW.NIKOLAOUTOOLS.GR
Solution
Check battery installation
Check battery charging requirements
Connect the battery to the charger
Connect the charger into a working outlet.
Check current at receptacle by plugging in a lamp or other
appliance
Check whether receptacle is connected to a light switch which
turns power off when you turn out the lights
Attempt to charge the battery in a room where the surrounding
air temperature is above 4,5 oC or below + 40,5 oC